The Ford Ranger does a bit of everything in the UAE: site visits during the week, beach and desert trips at the weekend, and the school run in between. That variety is exactly why its bed gets messy. One day it carries a tool bag and a ladder, the next a cool box, sand boards and a tent.
Here's how to keep a Ranger bed organized whatever it's carrying.
The midsize bed problem
The Ranger's bed is smaller than a full-size pickup's, so space matters more. Without anything to hold it, cargo slides into a pile against the front wall or the tailgate, and you lose the open floor you need for the next item. Small items are the worst: they roll into corners and under bigger loads.
What to look for in a Ranger bed organizer
- A cut for your trim and bed: a good fit edge to edge leaves no gaps for cargo to slip into.
- Holding points anywhere: you should be able to fix an item wherever it sits, not only at the tie-down points in the corners.
- Quick to change: if it takes longer to set up than to load, you'll stop using it.
- No drilling: holes in the bed are permanent, and they matter at resale.
- Room for other kit: it should work with bed slides and drawer systems if you use them.
How Gripteck fits the Ranger
Gripteck is a modular bed organization system. Interlocking 12" x 12" panels snap together into a mat across the floor, forming an X grid, and blockers plug into the grid tight against your cargo. You lay the mat, place your cargo and lock the blockers, and your gear stays where you put it on the highway and off it.
The Gripteck Ford Ranger kit includes:
- 20 interlocking 12" x 12" panels
- 30 edge strips
- 2 long blockers, 2 short tight-fit blockers and 2 adjustable blockers
- 8 slide ramps
There is also a dedicated Ranger Tremor kit in two bed lengths, and kits for the Raptor and other Ford trims. Not sure which bed you have? The size guide shows how to measure it in under a minute.
Ranger layouts that work
- Trade: tool chest at the front between the wheel wells, drill cases beside it, a parts bin and water cooler towards the tailgate where you can reach them.
- Off-road weekend: recovery gear and a compressor blocked in at the front, cool box in the middle, camping boxes and bags behind.
- Family: a box of blockers around shopping and water cartons so nothing tips on the drive home.
Need more holding points for a busy layout? Add a blocker set with six more blockers in one of four colours.
Install it yourself
Gripteck installs in minutes without tools or drilling: place the first panel, snap the rest on row by row, then finish the edges. The installation guide shows each step.
Every kit comes with free UAE shipping and a lifetime warranty.